limburgmetaal

hi Sander, Bed leveling done through the setup with the card As well as XY setting calibrated etc PVA setting was mentioned, 220° and 80 on the bed. I will try tomorrow the PLA/PVA as it looks that ABS/PVA is a non-starter the printer is standing in a normal office, we have put a cloth over the top with the last two attempt to eliminate the draft and loss of temp. Glue, we used the 3dlac spray

Hi Sander Thanks, I choose the ultimaker3 as this had the option to work with the PVA But whatever i print it will not stick below trial nr 3, and again a failure

i am trying to get ABS en PVA, initial the start-up was not sticking, but also the PLA is getting seperated from the PVA as well.,

has anybody made already a hood over the Ultimaker3 and a door to get a better temprature controll?

good morning all anybody got any advise on following; working on the 1st trials and trying to get to understand all settings. PVA on 220°, Bed on 80°, glas plate clean and spraid with 3dlac Problem the 1st bid of the print is not sticking to the bed any sugestions are welcom. thanks

thanks, but the idear on the network is to send files and to use the camera at the off-hourse printing, The mobile option does not add any fjnction as i see it now.

dear neotko i might been not clear, no this link is not the solution at all. with my windows 7 i don't get a pop-up and even if i ask to look for a new network, it will not give a connection. the question is, how to link the printer to the excisting network

can anybody tell me how to add the ultimaker 3 to an excisting wifi network? the wifi setup gives a hotpoint, but i can't find that on my win7 network connectors we did ask the vendor of the machine,but got no reply

Hello Anybody who can advice me. outside dimentions are correct, but the inside dimentions of the holes are all too small. the right bottom hole, should be 8 is 7.3 left keyhole should be 8x11, is 7.3x10.2 top keyhole should be 12x14, is 11.2x13.3 printed with the ultimaker 3