Jump to content
Ultimaker Community of 3D Printing Experts

superbike

Member
  • Content Count

    4
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
    CH
  1. superbike

    cura dont start on Win10 Home 1809

    thank you, here are the results: Disabling windows firewall lets cura not start, but disabling avira virus scanner (windows firewall is enabled again) lets start cure normal! If avira virus scanner is enabled then cura 4.0.0 runs only in "windows8 comatibility mode". whats to do that cura runs with enabled virus scanner normal under Win10 Home 1809?
  2. superbike

    Problems loading both Cura 3.6 and beta 4.0

    ... not alone,me too: Can any one help use?
  3. Hello, since Windows Update to 1809 i cant start cura; V3.6 or V4 Beta, both are hanging on "loading preferenzes ..." See the logfile from /C:\Users\xxxx\AppData\Roaming\cura\4.0. whats to do? cura.log
  4. hello, the heating bed does not work. The fault analysis has shown that the delivered heating bed does not correspond to that in the instructions. The connections are interchanged from the heating and sensor PT100! The terminals are not labeled; check with measurement: PT100 results in 100 -120 ohm, heating bed only 3-4 ohm. Luckily nothing goes wrong because the driver does not give any power to the wrong connected device.
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!