Wiley

Never mind everyone..........sorry to bother you all....I found it!

I guess I'm not looking in the right place....I have 3.4.1 and I do not see the "pause at height" in Extensions/Post Processing/ where it was before. Do I need to install it and, if so, where do I get it

All of the above problems happen on my UM3 Ext also when I use the pause at the layer number so I have gone to pause at height using mm. It does not crash the part this way, but I am not getting good results by just taking my layer height of .27 mm and multiplying by the layer number of 33. So I just finished a print using 33 * .27 = 8.91 It came out too low so I am trying a print at 10 mm right now. Maybe there is a scale factor on the .27 mm to help get a more accurate height. Right now the process is to print one and then make another guess for the next one. Got to be a better way....

Just a question from a 1 month old owner of a UM 3+....If I check the "Compensate Outer Wall Overlaps" box, what happens to the under size hole dia versus the outside dimension?