Jump to content

Hardlec

New member
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Field of Work
    Education
  • Country
    US
  • 3D printer
    Other

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. A solution of vinegar and water will clean glass very well with no dirt-releasing additives that impede adhesion. If you are worried about a tape seam, make a deliberate overlap of about 1 cm. With an exacto knife or similar tool and a metal straight-edge, make a cut all the way through both layers. Peel the tape back and remove the 5mm wide strips. The wider pieces will fit back together very precisely. Stencil adhesive can be found in most craft stores. A thin layer on the bed will encourage the plastic to adhere, but stencil adhesive will not form a permanent bond. Stencil adhesive is designed to hold a stencil in place, keep paint from flowing under the stencil, and allow the stencil, often a delicate thing, to be removed and re-used.
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!