I've recently made the transition to PETG from PLA on my Ender 3. I've been printing with eSun PETG at 240c nozzle, 80c bed, 40mm speed, 20mm initial layer and around .95-.97 extrusion multiplier. My prints have been looking good however, long story short if I do a drop test on a project of mine, the PETG breaks before the PLA everytime. I've been printing anywhere between 230c - 245c range but the results have been the same. Isnt PETG supposed to be stronger and less brittle? I'm always reading about how tough it is so I'm assuming there must be some user error somewhere, but I'm out of ideas at this point. The PETG has been breaking across the grain and delaminating before the PLA even with a 6 layer wall and bottom thickness as opposed to the PLA at 2 layers. Any thoughts would be greatly appreciated!
