Jump to content

PolyCraft

New member
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Field of Work
    Education
    Manufacturing
    Other
  • Country
    GB
  • 3D printer
    Ultimaker S5

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Hi all, I'm new to the forums and fairly new to the S5. I'm having a bit of trouble getting the S5 to find and use the Lift Switch properly, and it seems to have started with a 20 hour print job (Tough PLA, PVA) I had on recently. The parts had warped, the print bed had been knocked about 1 inch to the right, the silicone cover on the print head had been pulled out, and the print was offset on the X and Y axis part way through (but despite all of this it was still trying to print!). Just to be safe I performed a full maintenance cycle, including XY offset calibration and a lift switch calibration, but I'm still having issues. When I set a print to go the print head moves to the lift switch to change print cores, but seems to miss on the Y axis by about an inch (toward the back of the printer), even after all of the maintenance and calibration. Does anyone know why it might be doing this, and what I can do to fix it? Thanks in advance!
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!