Jump to content
Ultimaker Community of 3D Printing Experts

Starrfire

Member
  • Content Count

    5
  • Joined

  • Last visited

Everything posted by Starrfire

  1. Thanks! That seems quite possible - although shouldn't it build supports to them if they are not on the build plate?
  2. Slicing "teeth_top" from here: https://www.thingiverse.com/thing:2736627/files using Cura 4.1 I'm trying to use brim to help them adhere to the plate and it fails to draw a brim for a few of the teeth. The same problem happens with support enabled/disabled, raft and skirt too.
  3. I enabled "Print thin walls" and adaptive layers - in preview it's looking better now. I'm going to try printing it again.
  4. Image 1: prepare Image 2: preview Question: why are the rose petals floating in mid-air in preview? Is this just too fine to print? And in Cura are there any settings I can use to correct it? Note: I tried printing it (0.15mm normal quality) and the petals are a tangle of strands. Everything else looks perfect. Setup: Ender 3 Pro running Cura 4.0 Original - printed at 50% of its scale: https://www.thingiverse.com/thing:3304456/comments
×
×
  • Create New...