AlekLKL

The print is for a silicone candle mould - the posts is for wick holes in the mould. The printer also starts extruding when they are not there. It always starts extruding the exact same place, at all types of prints.

Hi! My Ultimaker S5 suddenly started extruding in the left corner and i pulling it back on my print - sometimes it result in a unusable print... It does it the same place, layer by layer. There is nothing there, in my Cura setup. I have set my UMS5 back to factory settings, but it did not help. I have attached pictures of the line that goes trough my print (is . Have anybody else tried this? I cannot find anything similar. Thank you! /Alek UMS5_Form nr 22 - facetteret kugle.3mf

Hi! My Ultimaker S5 suddenly started extruding in the left corner and i pulling it back on my print - sometimes it result in a unusable print... It does it the same place, layer by layer. There is nothing there, in my Cura setup. I have set my UMS5 back to factory settings, but it did not help. I have attached pictures of the line that goes trough my print (is . Have anybody else tried this? I cannot find anything similar. Thank you! /Alek