Vruize

Hello guys, I experienced the same thing, but I may miss something because I don't speak native english, so my english soso. but when i change the M420 to G29, my printer just stop in the midway from front left to centre. Any helps appreciated. thank you! *Edited I finally figure it out! for next visitor of this thread who have the same problem. Try to change this (in early gcode): G28 ;Home M420 S1 Z2 ;Enable ABL using saved Mesh and Fade Height To this: G28 ;Home G1 Z5 F5000 ; lift nozzle G29 ;Enable ABL using saved Mesh and Fade Height And remember to do it each time you make new slicing. Thank you so much for all help in this thread.

Thank you gr5, i kept searching for diagonal printing, didn't realize it could be type in as triangle. my english is just bad then. ^.^

Hello Everyone, I am newbie in this 3D Printing world, but i always try to search it before ask it. So, it's either my english is bad or no one have experiences it before. I use prusa slicer before this (and it didn't have this error), but i felt like the not much configuration in the print setting. Therefore, I change to CURA, it is awesome, i can control many things with the setting. However, when i slice it using CURA, my printer always print a diagonal line from middle to front (the side closer to you) left. I tried to find something in the setting, including in skirt, nothing changes it. So with CURA it prints by this sequence: 1. from front left to middle left, 2. from middle left to centre of bed (this is it), 3. from centre of the bed to front left (this is it) 4. start printing the skirt (stepping through the diagonal line). By Prusa it prints by this sequence: 1. from middle left to front left 2. start printing the skirt. I wonder if anyone have experiences this or have solution to fix this error of mine. Any suggestion is appreciated. Thank you all!