Carlbosson

My two cents, Looks like under extrusion to me as well. Go to youtube and find a video on how to calibrate the extruder on an Ender 3. They one this is done you may also want to find a video on how to calibrate the PID of your hot end. Then retry your prints. Good luck. Carl

I have now found the answer to the question I just asked. All the code is already there to home all at the end of the print but it dose not seem to doing what it is told? G Code.pdf

Sorry I did not see a search to look to see if this has been asked before and I am sure it has. When my print is finished the hot end stays on the print and cools so it is stuck to the print. I would like to add a line of code to the sliced file to tell the printer to home all once the print is complete. I would also like to add a swipe before the print starts. Were do I add this in Cura? Thank in advance for all your help.