theTicFramedtheadverb

question, sequential print. i have printed some thumbscrews, aboput 15 mm htight, 5 on the bed, sequentially. that works ok. now, suppose they were 150 mm high (creality Cr10 s pro) IS there a way to print these sequentialy, in SECTINOS; example, 1 through 5, 0-15 mm height; then 1 through 5, sequentially again, 16-30 mm height; then 1 through 5, sequentialy, 31 through 45 mm height? this way, the gantry is always above the top of any object, and the sequential print is done in batches. if that is NOT availalbe, where would i post it as a suggestion, as they do improvements to the software? and would such printing, in anyone's expert opinion, cause problems? thanks

Cods69, thanks again. SO, just to clarify IF I go into my Creality Cr10Spro, and turn OFF AUTO-Leveling, but STILL use the G29 code, Creality will READ the PREVIOUSLY STORED values every time it prints and then I can just go in and TURN ON AUTO-Leveling about every 10 prints, it will RE-DO those stored values? thanks

WOW ! Deceptive is not the word for it ! you hve to actually START to scroll before a scroll bar appears ! but i did find it ! Thanks very much !

and the reply Preferences/Configure Cura/Printers/Machine Settings/Start G-Code thanks for reply, but that does not work; the original slicing/calibaration code is not in the printer sdction of "start printer" that i can find. This seems to get added AFTER the start printer commands? unless I'm missing sometinng.. thnkas

thanks ! I will experiment ! but main thing is, if it is saving the mesh and using it for subsequent prints, that would be fine for some of the smaller jobs, and then just run the auto level for any significant large jobs

kvcaner - interesting, i am new at this, i've added this fix, BUT to clarify, if I do NOT add teh fix, but thrn OFF the auto leveling in the Creality Cr10S pro, that the trinagle would not occur AND the bed leveling would not occur? and THEN I could just do a MANUAL level routine periodically, and creality would then use the MOST RECENT GENERATED values fo rthe subsequent prints, until the next leveling? or, to get rid of triangle, do i still need to have the modified code? thanks

to all, the solution is successful, but is there a way in CURA to put this in as a permanent change or add-on, to remove the other lines? currently i have to edit every one of my .gcode files as they are generated. thans

thanks to ALL for this thread !! I thought I was going crazy !! I will try these solutions in next couple prints I have so many triangles that scraping them off has made that section of the bed smoother than the other sections ! Again, thanks. ALSO, question - is it worth sending CREALITY OFFICIAL, through FACEBOOK (send a message), a link to THIS thread, and to the GITHUB thread that was posted in this thread, requesting that they look at this, and try to fix it? or is that GITHUB thread enough to get their attention?