Hi
I have got a S5 for about a week.
However, when I print some large job, after the 1st layer, I have the error massege on the screen says" material is empty" whilst plenty of material is on the spool.
I pull out the filement and noticed there was significant grinding.
I did some research and have disassembled the feeder and cleaned it. Set the tension to the lowerest. But the same problem still not solved.
So far I am having problems with PLA and tough PLA, haven't tried other material yet.
It seems the grinding happened after retraction. My retraction setting is "Retract at layer change and minimum retract travel 0.3mm"
Please help, this is a very expensive printer and seems I can't use it's full potential.
Many Thanks
Sheng