Hello,
I've just bought a brand new UM2C, coming from UM2GO.
I'm very happy with the print quality, it's a real gap.
But I'm quite disapointed by the software : there are way less options that on my previous printer, and it's heavily slow.
Some details :
1. I've added a Ziflex on the plate, but unfortunately I can't use my printer anymore because the calibration is only physical (using screws) and I've reach the end before teh right settings. On the Ultimaker 2 Go there is a 'software' calibration first where you can move the plate up and done, which would solve this issues. How can I do the same ?
2. It's very slow to start, much much more than my old UM2GO, way more than my laptop... And it's brand new, what's happening ?
3. The feature "Skip cooldown" introduces some bugs : If I change the material, then skip cooldown, and immediately start a print, it will hang forever on the "preparing" screen.
4. How can I change settings while printing, like the printing speed ?
5. I'd like to use my printer on my local network, without internet, how can I do that ?
6. The open WiFi of the printer is always on, even after it's connected to my network, how can I disabled it ?
I'm on firmware 1.2
Thanks for your help.
Have a nice day.