-
Posts
19 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by gustrowsky
-
-
Hey @LePaul! I am printing the same skeleton that you are and I am having an issue on the corners. It seems to under extrude only on the left side corner. What are all your settings? If you could use File | Save Project and post the 3mf file that would be good. Thanks.
-
-
Thanks for those settings. They're probably better than mine anyway 🙂 How do I get rid of that grey box around the print? I want to print the whole thing. Thanks for everything!
-
-
-
Thank you so much! I reinstalled Cura to 4.9 and it prints dead center now. I will leave you updates on the other part. Thaks!
-
We tried this and it didnt make any difference. Here is the file. I have an anycubic chiron. (X400 Y400 Z450) Thank you for your help
-
My MINX and MINY is negative. That is my problem. Do I just delete the negatives or change the numbers too? Also, when I try to edit the gcode it doesn't change anything. Thanks!
-
Thanks, but the problem is not with z axis. It prints the right height, but it starts printing too far off the left of the board as you're facing it (that means the x axis is starting negative numbers right?). How do we fix that?
-
I have it centered in Cura, but it starts printing off the bed. Is my g-code messed up? Thank you.
-
Thanks so much for your help. I will try the printing tower and thanks for helping. I will share my results soon.
-
Here is my file. Thank you for your support!
-
-
Thank you! I got perfect results when I did this.
-
Thank you so much! It must be the nozzle. I will change it and share my results. Yes, I use PLA.
-
Thanks!
-
Ive been using Cura for a while now and a question i had was about the Cura supports. Cura seems to put down a lot of unnecessary supports. is there a way I can make this software use less supports? Thanks.
-
Hello everyone. I am trying to 3d print a part on my Anycubic Chiron. I am having trouble with the sides of the print warping which causes the whole thing to curl. I've tried everything recommended- glues, painters tape, heated bed. I've experimented with bed at 60, 65, 70, and 50 degrees, and the head temp at 180-190 degrees. nothing seems to help. I'm currently taping down the helper disks and it seems to be working, but i know i shouldn't have to do that. Any advice for this? I would really like some help. Thanks!
Graham
Error 500 accessing forum
in UltiMaker.com
Posted
I am printing with the curve of the piece facing forward. It is straight. I am using gray Anycubic filament. It had good reviews. I tried using supports on the edge there where it's messing up, but that didn't help. Here's my settings.
CaryChristieSkeleton.3mf