gustrowsky

I am printing with the curve of the piece facing forward. It is straight. I am using gray Anycubic filament. It had good reviews. I tried using supports on the edge there where it's messing up, but that didn't help. Here's my settings. CaryChristieSkeleton.3mf

Hey @LePaul! I am printing the same skeleton that you are and I am having an issue on the corners. It seems to under extrude only on the left side corner. What are all your settings? If you could use File | Save Project and post the 3mf file that would be good. Thanks.

This box. I think it's there because you are only printing the top 3/4.

Thanks for those settings. They're probably better than mine anyway 🙂 How do I get rid of that grey box around the print? I want to print the whole thing. Thanks for everything!

I have combing and coasting off... InnerSkeletonV1.3mf

So, I have one perfect corner and one messed-up one. Would re-leveling fix this?

Thank you so much! I reinstalled Cura to 4.9 and it prints dead center now. I will leave you updates on the other part. Thaks!

We tried this and it didnt make any difference. Here is the file. I have an anycubic chiron. (X400 Y400 Z450) Thank you for your help AC_temp-calibration-block.gcode

My MINX and MINY is negative. That is my problem. Do I just delete the negatives or change the numbers too? Also, when I try to edit the gcode it doesn't change anything. Thanks!

Thanks, but the problem is not with z axis. It prints the right height, but it starts printing too far off the left of the board as you're facing it (that means the x axis is starting negative numbers right?). How do we fix that?

I have it centered in Cura, but it starts printing off the bed. Is my g-code messed up? Thank you.

Thanks so much for your help. I will try the printing tower and thanks for helping. I will share my results soon.

Here is my file. Thank you for your support! BB-8 skeleton file.3mf

Hello everyone. I am 3d printing this piece and I am getting some issues I can't find solutions for. I have images attached. Thank you!

Thank you! I got perfect results when I did this.

Thank you so much! It must be the nozzle. I will change it and share my results. Yes, I use PLA.

Thanks!

Ive been using Cura for a while now and a question i had was about the Cura supports. Cura seems to put down a lot of unnecessary supports. is there a way I can make this software use less supports? Thanks.

Hello everyone. I am trying to 3d print a part on my Anycubic Chiron. I am having trouble with the sides of the print warping which causes the whole thing to curl. I've tried everything recommended- glues, painters tape, heated bed. I've experimented with bed at 60, 65, 70, and 50 degrees, and the head temp at 180-190 degrees. nothing seems to help. I'm currently taping down the helper disks and it seems to be working, but i know i shouldn't have to do that. Any advice for this? I would really like some help. Thanks! Graham