UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Hi Guys
Non idex printer with twin heads - is it possible to set the second extruder as a backup in case the first head blocks/jams/runs out of filament?
Many thanks!
Ah, ok.
Have previously been using craftware for an idex machine and when you are printing in parallel or mirror mode it effectively splits the bed in half and uses one extruder per side, so was hoping to achieve the same in cura🙂
Thanks again🙏
Thanks so much for the reply, really appreciate it!
Out of curiosity whats the logic in locking the extruder/support up? Surely you could print multiple objects faster if it was unlocked.
Thanks again!
I'm trying to get a printer with two extruders to print separate objects but cura always wants to assign one of the heads to do all the supports.
Print settings - Support - Generate support (ticked) - Support extruder etc is then locked to one nominated extruder
Is there any way to unlock it?
Thanks🙏
Hi again again - you can't beat talking to yourself!😁
So think I'm going to have a bash at this...
In machine settings put the printer settings in.
Start G code is now
G28 X Y ; home horizontally
G28 Z ; home vertically
And end code is
G91
G0 E-1 F2400 ; retract 1mm
G0 Z5 F2400 ; lift Z 5mm
G90
G28 X Y ; home horizontally
G0 Y250
Think I may need to add
M425 S1; Wiper Strip enabled
to the header code.
If anyone wants to comment I'd be grateful!
Update... Have given it a run on benchy and it appears to work well.
Hi again.
I guess I could rephrase the question and ask what information I need to put into cura and can I get it by reading the g code from a craftbot print?
Thanks again.
Hi all🙂
Please be gentle, quite new to all this, but was hoping someone could help with setting up cura for a craftbot idex xl
Any help greatly appreciated!