I've recently started noticing that my ender 3 has starting leaving a hole or pit in the last place my nozzle was in my prints as can
be seen in the picture. I have tried altering my end Gcode however I can't seem to find the problem. I am currently using cura 4.9.1 however I also tried cura 4.8 and I had the same issue there. This is my current end Gcode:
G91 ;Relative positioning
G1 E-2 F2700 ;Retract a bit
G1 E-2 Z0.2 F2400 ;Retract and raise Z
G1 X5 Y5 F3000 ;Wipe out
G1 Z10 ;Raise Z more
G28 X0 Y0 ;move X/Y to min endstops, so the head is out of the way
G1 Y100 F5000 ;move bed forward (Y)10mm to remove part at (F)5000 feed rate
G1 X0 Y{0} ;Present print
M106 S0 ;Turn-off fan
M104 S0 ;Turn-off hotend
M140 S0 ;Turn-off bed
M84 ;Disable all steppers
If anyone knows a solutions I would love to hear it:)