lavi

Hello, Last week I just update the firmware 5.2.17 and I found that the camera couldn't show on Cura. I tried 【http://xxx.xxx.xxx.xxx:8080/?action=stream 】and the camera could show on browser. Besides I can used remote printing via internet cable .It means that the network is fine. So,what happened to this problem? Does it relate to software?I have tried Cura 4.10 and Cura 4.2.1. How to solve it? Thanks for viewing

Thanks for replying. I re-updated the firmware 5.2.17.20210723 by connecting Wifi and this time Cura could connect printer by internet cable. I were still not sure what happened to it... But it still had the same problem that the language still can't show Chinese on LED monitor. Hope later will fix this bug.

Hi, I just update firmware 5.2.17.20210723.But something wrong happened. My Ultimaker cura 4.10.0 can't connect the printer Ultimaker 3 via internet cable. Even cura can detect printer's IP,and it just disconnect after connect for a short time. How to solve this problem? It drived me crazy..... Thanks