mekkeyz

Could it be the Flow Rate Compensation Factor, because im not quite sure what it means

Hello, I have a anycubic i3 mega printer with included firmware, im not planning on changing it, because it works fine in my opinion and im too scared to do it. Recently ive changed my extruder to a aliexpress version of titan and it requires more steps from the motor to make for the same fillament ammount to extrude. Im not quite sure if theres any other way to change it in cura but i just increased the flow and it works fine, but it affects the preview and the estimated cost and fillament usage which is quite annoying. Is there any other way to change it in cura?