BarraVox

Hi I have selected Lift Head to maintain Minimum Layer Time in the Cooling section however while lifted I am getting oozing because the filament is not retracted. That is making a mess on the print. Enable Retraction is set in the Travel section. How can I get retraction during the Lift Head ? Cura Version 5.0.0

Thanks. I guess the postprocessing diaglog will be OK, is there manual for how to add settings to that diaglog?

Hi I want to create a postprocessing script but I want to control an aspect of it with a setting. Can I add a custom setting in Cura to control a variable in a postprocessing script? How?

ah, managed it! had to set "Wall Line Count" in the blocker settings. It adds an unnecessary wall but I can live with that.:

Hi, I want a particular part of this print to be stronger so have used a Support blocker with "modify settings for overlaps" to modify infill settings to 100% in that part. But for some reason Cura is leaving a gap between the 100% infill and the rest of the print as shown in the preview below Obviously this is reversing any strength gain for the 100% infill. It does this for any infill setting in the support blocker, this is 50%: What is happening? - how can I get part of the print with a different infill properly attached to the print? I am using Cura version 4.13.1