BlasterGales

here it is AET5_xyzCalibration_cube.3mf

The prepared prints in Cura have imprecision in the X and Y axes. The printer profile used is Anet ET5 (same as my printer) and the profile used for the test is the Draft (0.2), the result is an object that differs from the measurements that can be seen in the preparation of the project, leaving a 20mm test cube with a difference in the Y axis of 98.56% and in the X axis of 100.78% as I could measure, there are no differences in the Z axis. Slic3r no has this problem, so it seems to be a problem in the Cura printer profile.