dunni88

I'm having the problem too. I have a hollow part that has bottom layers and top layers. 0% infill works fine for the whole thing due to the shape. However, the top does have about a 1 inch opening that I want to bridge. When I enable bridge settings it doesn't see the top as a bridge because there is material underneath it. It doesn't matter that the material is not doing anything to support it. I think this is just a problem with how this threshold works. The only way for it to see the top as a bridge is to set the "bridge skin support threshold" to 100%. But then it sees the bottom layers as a bridge as well and applies the same settings to it.

I'd like to get a profile for the Elegoo Neptune 3 on Cura 5.1.1. I wish they'd just have it as an option for one of the presets. Is Elegoo resistant to allowing that for some reason?