BEprints

Hi I am printing some swords for my nephews for Christmas. The problem I have is the blade is hollow and would like to add infill in the blade, If I use the Remove All Holes option it works but it also removes functional holes I need, I thought maybe a block with modified settings would do the trick to add or remove the Remove All Holes option but unfortunately it doesn't seem to work. It this something that can be done or do I need to go another direction to be able to have infill in the blade part. Any help would be appreciated

Thanks I will try it out tomorrow

Hi I am new to Cura I am trying to maximize my print times and I change my start gcode in Cura but for some reason when I slice and go to print the bed temp and nozzle temp go way to high but if I save the gcode then manual edit the start gcode it runs fine. This is the start gcode I would like to run ; Ender 3 Custom Start G-code M117 Pre-heating the extruder! M104 S170; start warming extruder to 170 M140 S60{material_bed_temperature_layer_0} ; Set Heat Bed temperature M190 S60{material_bed_temperature_layer_0} ; Wait for Heat Bed temperature G28 ; Home all axes G29 A ; Activate bed mesh -level (CR-Touch) G29 L0 ; Load mesh from slot 0 G29 J3 ; Probe for bed tilt G1 X245 Y218.5 Z1 F5000.0 G92 E0 ; Reset extruder M104 S215{material_print_temperature_layer_0} ; Set Extruder temperature M109 S215{material_print_temperature_layer_0} ; Wait for Extruder temperature G1 Z1.0 F3000 ; move z up little to prevent scratching of surface G1 X225 Y200 Z0.3 F5000.0 ; move to start-line position G1 X225 Y20 Z0.3 F1500.0 E15 ; draw 1st line G1 X222.2 Y20 Z0.3 F5000.0 ; move to side a little G1 X222.2 Y200 Z0.3 F1500.0 E30 ; draw 2nd line G92 E0 ; reset extruder G1 Z1.0 F3000 ; move z up little to prevent scratching of surface ; End of custom start GCode

Thanks that was it I has to lower the amount of minimum layer time

Hi all I am after some help Using Cura 5.1.1 and trying to print faster but only skirt/brim, initial speeds and top/bottom speeds will change will changer as soon as it gets to a wall it slows down even though all the speeds are set the same. Am I missing something or is it a bug? Printer is a ender 3 v2 running Jyers Marlin 2.1 firmware