chubbychubz99
-
Posts
3 -
Joined
-
Last visited
chubbychubz99's Achievements
0
Reputation
-
Hello, I wanted to know if there was a way to set the flow rate at different X&Y points on the same layer? Say that I need different percentage when an infill and a flat surface are on the same layer.
-
Embedding things within prints
chubbychubz99 replied to chubbychubz99's topic in Improve your 3D prints
thank you -
Is there a why to add preloaded stops in the build to allow the embedding of other things like magnets within the 3D print?