FDCW
-
Posts
12 -
Joined
-
Last visited
FDCW's Achievements
0
Reputation
-
I lost my thinking cap long ago but with all my 3D printing adventures (at work and at home) I may just be able to print one and use it for what it's intended. I'm far from being any kind of programmer but I understand what you mean, I just need to practice.
-
It worked perfectly, Thx GV
-
So could I have just raised the letters in Cura by measuring the height and print?
-
WOW!!! so far so good, I'll repost again when done. Thank you SIR!
-
GV, I will try your Gcode and post the results here. The bed is cool but NOTHING moved.
-
Unfortunately, I was not present at the time and the printer was turned off, it does not have a Touch sensor. This seems to be a bit complicated for a few $ of filament. If I was at home I would probably try this but I'm at work so I'll just reprint it. I will try a sample of Pause at height before reprinting the whole thing, thx for the advice. Thank you Slashee_the_Cow
-
Anycubic Kobra 2 Max. My main goal here is to continue this print. CFFFP_Puzzle with removed bottom..3mf CFFFP_Puzzle with removed bottom..gcode
-
I tried to change color (Filament change) at layer 15 but the print just ended at that point instead. How do I continue this print. I tried opening the Gcode in a text file to no avail. I'm running Cura 5.5.0. I was just able to open the Gcode file in Notepad. This is my first time doing this so from here I'm not 100% how to edit the GCODE.
-
Well, I ran the XY cal again and it improved by a lot but there is still a small overlap on the X axis, I may have to add an offset to one of the nozzles.
-
PLA in nozzle 1 and natural PVA in nozzle 2. I don't like that the PVA is printed on top of the PLA which creates defects in the final print.
-
I didn't measure the offset, I measured between both nozzles to make sure that the distance was 22mm. I did run the XY Cal, twice but does the Cal adjust the offset between both nozzles? I though it only checked the XY which is not the issue here because when I use only one nozzle it prints very well.
-
Hi, I have an Offset between nozzle 1 and 2 and I can't seem to get a good print using both nozzles. Ultimaker S5, Rev 8.2.0, I measured between both nozzles and I do have 22mm. See attached pictures. pls advise
