sketchy984

Hi trying to install on another computer and have this trouble. Seems unresolved... Tried everything on this thread, single monitor, changed directory, deleted all appdata Installing on windows 10.

Hey bud, thanks for the input. Nozzle temp is 145 deg. Yes it is a bowden extruder but it is running an all metal hotend so if you use 6mm retract you will get a blockage. I used to use 6mm on the standard hotend. Hotend manufacturer specifies less than 5mm for retract. Yes it is dry - spent 9 hrs in the dryer before printing. I've also cleaned hotend without improvement. I've attached the file The issue starts at the seam. When the nozzle travels to the seam and when it starts to move is when is doesn't extrude. PETG_BATT.3mf

I have a problem with extrusion on these parts. The same issue occurs each time I print. It prints fine with PLA but PETG it doesn't like. Printer: Ender 5 Plus with a lot of hours on it. The Slicer is Cura Hot end is a speedy spider v3 I've tried different retract settings between 1.5 and 3mm, with no effect so I have stuck with 3mm. Retract speed 35mm/s