Simonsrk
-
Posts
8 -
Joined
-
Last visited
Simonsrk's Achievements
0
Reputation
-
Thank you
-
- here you go! I ran the print and it printed in 33min, rather than the 28, so an additional 5 mins isn't the end of the world. Also, a lovely finish on it too. Now to try the settings on something else! 🙂 AI3M_xyzCalibration_cube.gcode
-
Okay, Based on your recommendations, I've reset my Vyper to the settings on this 3mf file. Could you please let me know if there's anything else I can do to improve the quality of my print all the while keeping the timings down to something reasonable? It says it should take 28 minutes with these settings, so I'm going to run it once my current print has finished - currently it's at 67% and has taken 2H 59 minutes for some keys using grey Anycubic PLA. Thank you in advance. AI3M_xyzCalibration_cube.3mf
-
Okay, so, here's a calibration XYZ block. Not sure about the settings helping, but you never know. I think my top layer is too thin as I'm getting an incomplete finish on the top. Any suggestions would be gratefully appreciated. Cheers. AI3M_xyzCalibration_cube.3mf
-
I’m running an Anycubic Vyper for my 3D prints and aside from it running beautifully, this is the only problem I have. I always thought Cura to be THE go-to for slicing, lately I’m seeing its flaws!
-
This is so annoying. I'm currently going through my settings and ran a test print last night of a standard six-sided die. Nearly an hour and a half l later (1hrs 26 mins) it finished! There really is something amiss with the settings as it was supposed to be a twenty minute print. Getting fed-up now!
-
Hi all! Does anyone have any top tips for fast - but good quality print settings in Cura, as I just can’t balance the settings to allow my Anycubic Vyper to have a quick turnaround, but with a really nice finish too! Any and all tips and tricks would be gratefully appreciated! Thank you 😊
-
Hi all! This is my first post on the forums, so be gentle! I’ve been into 3D printing for several years now and am very lucky to own a resin printer and a filament printer. However it’s the latter i really have a problem with, as Cura just doesn’t show the right print times for anything! Now it could be Cura, or it could be my Anycubic Vyper, however, if it says something will print in an hour and a half - add another hour to it. Large things can take an additional hour, small things an extra half an hour. What’s happening here as I’m not exactly sure how to marry everything up with the correct timings. Thank you 🙂