Jump to content

EPS Files won't load into Cura. Calculating stuck around 20-25%. Extremely low size files. Why?


ScottG2187

Recommended Posts

Posted · EPS Files won't load into Cura. Calculating stuck around 20-25%. Extremely low size files. Why?

I am trying to load 5 EPS files into Cura one at a time. I have successfully loaded 2 of them and converted to gcode files. These two were 61 KB and 64 KB. But the 3 smaller size EPS files. 2 KB, 9 KB, and 18 KB will not load. It says calculating (with ??? on both sides) like it is processing then stays stuck at around 20-25% on the progress bar... I've let it go for over an hour and nothing changes. I've tried loading files by double clicking in folder and by File >Open within Cura. Nothing works. I've tried re-downloading these files from the source and attempting. Still no difference. I can see the visual, just can't do anything. Why can the bigger files load and convert with no problem but smaller not at all? Any help or insight would be much appreciated.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 15 replies
      • S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
    ×
    ×
    • Create New...