UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Ca viendrait visiblement d'un jumper mal positionné sur la carte:
Easy fix! This is usually caused by the Z stepper jumper being wrong. I even still have a picture in my gallery of it
Click on the image above and look at the red circled part carefully. You want yours like that. The right most jumper should be either removed or placed as shown in the picture so that it does nothing (connects the pin to thin air). I suspect your right most connector is in place like the 2 next to it.
Here comes Cura 5.9 and in this stable release we have lots of material and printer profiles for UltiMaker printers, including the newly released Sketch Sprint. Additionally, scarf seams have been introduced alongside even more print settings and improvements. Check out the rest of this article to find out the details on all of that and more
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
DidierKlein 729
Regarde ce sujet
Ca viendrait visiblement d'un jumper mal positionné sur la carte:
Link to post
Share on other sites