Jump to content
Ultimaker Community of 3D Printing Experts

Printing stopped....


Recommended Posts

Posted · Printing stopped....

Hello community,

Is it possible to resume printing stopped after a power outage.

I use UM in standalone mode, with Uliticontroller SD card.

If this is not possible, I intend to use an inverter.

thanks for your advice.

A + Willy.

  • Link to post
    Share on other sites

    Posted · Printing stopped....

    It's not possible without some GCode editing by hand. The machine does not know where it stopped. So you have to manually figure that out, and delete all the GCode up to that point. It's difficult to get a good resume.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now

    • Our picks

      • New here? Get ahead with a free onboarding course
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 12 replies
    • Create New...