Jump to content

reasign pin`s from Ex1 to X


Recommended Posts

Posted · reasign pin`s from Ex1 to X

hi, i had a problem with x pololulu and it´s burned. everythig its working but the X axe not. i dont use a second extruder and i whant to reasing the pins of EX1 to X ax. i found it on marlin firmware but i dond see the pin numeration on the pcb. THX

#define X_STEP_PIN 25

#define X_DIR_PIN 23

#define X_MIN_PIN 22

#define X_MAX_PIN 24

#define X_ENABLE_PIN 27

#define E1_STEP_PIN 49

#define E1_DIR_PIN 47

#define E1_ENABLE_PIN 48

  • Link to post
    Share on other sites

    Posted · reasign pin`s from Ex1 to X

    solved:

    #define X_STEP_PIN 49 //25

    #define X_DIR_PIN 47 //23

    #define X_MIN_PIN 22

    #define X_MAX_PIN 24

    #define X_ENABLE_PIN 48 //27

    //#define E1_STEP_PIN 49

    //#define E1_DIR_PIN 47

    //#define E1_ENABLE_PIN 48

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 7 replies
      • S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
    ×
    ×
    • Create New...