Ultimaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
dein beschriebenes Problem nennt sich Unterextrusion. Es wird nicht die erforderliche Menge Kunststoff durch die Düse gefördert, die benötigt wird. Dies kann viele Ursachen haben.
Nachfolgend ein Link zu einem Troubleshooting Guide:
We don't often release an alpha version of Ultimaker Cura... So what's different this time? This Alpha contains such a huge slicing engine overhaul that we really need your help!
We wish to celebrate and honor the innovators that push forward the field, technology and world. We opted to not present it as a competition or ranked list. Every innovator has earned his spot on that list in their own way. We also look at the 3D printing industry as a whole and not limit the list to those only using Ultimaker.
Recommended Posts
HMarcus 5
Hallo und herzlich willkommen im Forum,
dein beschriebenes Problem nennt sich Unterextrusion. Es wird nicht die erforderliche Menge Kunststoff durch die Düse gefördert, die benötigt wird. Dies kann viele Ursachen haben.
Nachfolgend ein Link zu einem Troubleshooting Guide:
http://support.3dverkstan.se/article/23-a-visual-ultimaker-troubleshooting-guide
Hier solltest du deine Lösung des Problemes finden.
Edited by GuestLink to post
Share on other sites