File transfer for 3d printing

[OZATAPO 0]

Hi, I am thinking about Ultimaker 2+. I use Daz Studio 4.7 (64bit) and Carrara 8.5 (64bit) can I export files as .obj files into Autodesk Memento, then export as .stl files into Cura for 3d printing on Ultimaker 2+? Daz and Carrara dont export as .stl files.

[SandervG 1,521]

Hi @Ozatapo,

Welcome to the forum!

Cura can handle .obj files as well, so make sure to convert your file into a solid mesh and upload it in Cura. In Cura you can convert your .obj into a gcode by selecting your 3D printing profile and you are ready to go

[OZATAPO 0]

Thank you very much, this gets me a step closer to decision.