CURA 12.1 ABSquickprint mode cannot cancel support structure

[fritz99 0]

Hello !

When I want to print with the quickprint mode with ABS it does not matter if I check or uncheck the "print support struchture ".

It always prints the support structure.

Please help

Fritz

[Daid 306]

PLA or ABS?

[fritz99 0]

PLA or ABS?

ABS

Fritz

[Daid 306]

ABS quickprint always enables a raft. That's what you are seeing.

[fritz99 0]

ABS quickprint always enables a raft. That's what you are seeing.

The problem is that the raft is also under the printed piece and cannot be cut off.

So the underside is not as it should be.

Fritz

[Daid 306]

That's kinda the downside of a raft, but printing ABS without a heated bed on an UM is almost impossible without a raft. If you want more control, don't use quickprint.

[fritz99 0]

That's kinda the downside of a raft, but printing ABS without a heated bed on an UM is almost impossible without a raft. If you want more control, don't use quickprint.

I have a hotbed.

Fritz