Jump to content
Ultimaker Community of 3D Printing Experts
cyanfire

Missing one exact layer

Recommended Posts

So I haven't had my Ultimaker 2 for that long, loving it so far. But it has started very consistently missing out just one layer, about 1cm into any print. Sometimes it just causes an ugly line, and the pieces loose a lot of strength as they are not as stuck together as they ought to be. It is much worse when it needs to print support structure, this is so flimsy that the nozzle movement can cause it to snap half way through the whole print, causes a plastic chaos.

Anybody know why this is happening? My first thought was an extruder problem, but I find it odd that it only happens for 1 layer, always at the same height (about 1cm). I have tried releveling the bed, but that hasn't changed anything. So I am all out of ideas! Please help

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!