UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Posted
· Maximum rectangle that can be printed on UM2 +
Hi Franny500,
I attached a Cura image for you which shows a bit what you were looking for.
The fact is that there are glass clips on the bed which take a way a few mm in the corners of the print bed. So the largest square will be a little bit smaller than for example the print I choose. I would advice to go no larger than 221x221 mm to reduce the risk of your printhead slamming against the sides. Other than that you are good to go!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
Recommended Posts
Mumzelbaby 4
Hi Franny500,
I attached a Cura image for you which shows a bit what you were looking for.
The fact is that there are glass clips on the bed which take a way a few mm in the corners of the print bed. So the largest square will be a little bit smaller than for example the print I choose. I would advice to go no larger than 221x221 mm to reduce the risk of your printhead slamming against the sides. Other than that you are good to go!
Link to post
Share on other sites
Franny500 9
Thanks Mumzel, will forware that image. Think they were slightly disgruntled with the fact the website states 223 x 223mm.
Thanks again fro your help![:)](//content.invisioncic.com/ultimake/emoticons/5a33abdf6d109_1f60acopy.png)
Link to post
Share on other sites