Jump to content
Ultimaker Community of 3D Printing Experts
Wisar

Signals on the Expansion Connector Pins

Recommended Posts

Are there any signals already on the pins that are available on the Expansion Connectors? Obviously this being an open source environment I could go into the firmware and raise whatever signals I might want ... but this would take time and effort. In particular I am hoping that one of those pins goes to high when the extruder is active?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!