minivipers 25 Posted October 17, 2016 in Filamentchange excessive lenght. (edited) Hello, I try to modify and shorten the filament change lenght in arduino. both changing and loading lenght is aproximately 60cm is longer including bowden tube leght. I found this titled in marlin as "configuration_adv.h" ; but in any changing there is no changing at all...60 cm is extra after bowden tube. anyone knows the solution for this.? //adds support for experimental filament exchange support M600; requires display #ifdef ULTIPANEL //#define FILAMENTCHANGEENABLE #ifdef FILAMENTCHANGEENABLE #define FILAMENTCHANGE_XPOS 3 #define FILAMENTCHANGE_YPOS 3 #define FILAMENTCHANGE_ZADD 10 #define FILAMENTCHANGE_FIRSTRETRACT -2 #define FILAMENTCHANGE_FINALRETRACT -100 #endif #endif Edited October 17, 2016 by Guest Share this post Link to post Share on other sites
minivipers 25 Posted October 17, 2016 in Filamentchange excessive lenght. m600 is the mid material changing...I am trying to change filamnet at main menu in marlin Share this post Link to post Share on other sites
