Cura 2.3 Spiralized Outer Contour setting?

[Mazarini 0]

I received my UM2 Ext+ today and I'm printing with a relatively unknown filament (ApolloX). It should also be noted that this is my first experience with Cura and 3D printing in general. I am looking for the "Spiralized Outer Contour" setting in 2.3? could someone possibly point me in the right direction?

M

[bagel-orb 61]

Go to the advanced tab on the right and scroll down to the Special Modes category.

If it's not visible, go to preferences > settings; type 'spiralize' and enable the spiralize setting.

It should then have become visible in the settings tab.