Jump to content
Ultimaker Community of 3D Printing Experts
martins

101hero troubleshooting

Recommended Posts

Hi!

Can anybody help me? I have similar problems with my 101hero. I tried to change SDHC to SD card installed drivers on my windows 10 tried to connect to cura and repitier host even set up octopi but in windows it says it could not reconize it and in rpi3 that it could not connect to it automaticaly. Do i need to install some drivers on octopi?

Another problem: sometimes when i try to print via sd card it does something and stop and do it all over again. once i even diconected sd card but it still does it.

please help me!

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 114 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!