Jump to content
Lukephos

How to set cura for a 0.5mm nozzle?

Recommended Posts

Posted · How to set cura for a 0.5mm nozzle?

I didnt notice that the steel nozzle I bought was 0.5mm wide. It still works with my ultimaker 2+ fine but I cant find a way to set cura for that nozzle diamitor, only allowing presets. I know Simplify3D can do that but I cant afford it, and would still like to be able to do it in cura. It isnt that important since I found a set of the regular sizes (0.25, 0.4, 0.6 and 0.8) that I will get for my birthday next month, but it still is good to know and I'd like to finally be able to use the wood filament I got.

Share this post


Link to post
Share on other sites
Posted · How to set cura for a 0.5mm nozzle?

@Lukephos: I've moved the post here because it fits better.

Regarding your question, I think the easiest way is to change the "Line Width" under "Quality".

Share this post


Link to post
Share on other sites
Posted · How to set cura for a 0.5mm nozzle?

@Lukephos: I've moved the post here because it fits better.

Regarding your question, I think the easiest way is to change the "Line Width" under "Quality".

 

Thanks, that helped a lot.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!