UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I have had it hit the print if there is curling and such on edges. And, I have found that having the springs not too tight will let it give a bit if it hits a blob or something. That usually happens when the priming tower fails and it drags some plastic onto an area and creates a not so even surface.
But I have never had the print get hit so strong though, that it could move the plate. The clips may be a bit loose.
If the plate clips are loose, try to push them down, with the plate not in place, a bit to grip the plate better.
Also, how did you level? Manual? Active? I usually have to do a manual every now and then to bring it back into alignment after changing buildplates many times, or if I banged the plate with me clumsy fingers and bounced the plate down on the springs, but I always run an active after that.
Yup, maybe that's the issue. I've always used active leveling. Now, I'll calibrate Z axis once again, and do the manual leveling for the first time. Maybe the springs and the screws was the problem. Thank you for the reply!
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
kmanstudios 1,120
I have had it hit the print if there is curling and such on edges. And, I have found that having the springs not too tight will let it give a bit if it hits a blob or something. That usually happens when the priming tower fails and it drags some plastic onto an area and creates a not so even surface.
But I have never had the print get hit so strong though, that it could move the plate. The clips may be a bit loose.
If the plate clips are loose, try to push them down, with the plate not in place, a bit to grip the plate better.
Also, how did you level? Manual? Active? I usually have to do a manual every now and then to bring it back into alignment after changing buildplates many times, or if I banged the plate with me clumsy fingers and bounced the plate down on the springs, but I always run an active after that.
Link to post
Share on other sites
swinkaszynka 0
Yup, maybe that's the issue. I've always used active leveling. Now, I'll calibrate Z axis once again, and do the manual leveling for the first time. Maybe the springs and the screws was the problem. Thank you for the reply!
Link to post
Share on other sites