Jump to content
Ultimaker Community of 3D Printing Experts

Why is cura placing support under layer 1?


Pyrex

Recommended Posts

Posted · Why is cura placing support under layer 1?

For some reason I've run into this problem with cura on multiple occasions. Cura is placing support under the first layer of my model, it makes no sense. This bug has happened to me a few times before and I could overcome it with adjusting the support angle, but on my most recent model I can't. Can anyone explain this?

2017-07-06_19-19-30.thumb.jpg.4d5ca1871797feb56a510f6d23686fe5.jpg

2017-07-06_19-19-30.thumb.jpg.4d5ca1871797feb56a510f6d23686fe5.jpg

  • Link to post
    Share on other sites
    • 3 weeks later...
    Posted · Why is cura placing support under layer 1?

    Hi,

    Im experiencing the exact same problem.

    Vtl4LEF.jpg

    It seems to happen when support is enabled. It's like if the model was sitting on an "air raft".

    Haven't found a fix yet. Im downgrading Cura...

  • Link to post
    Share on other sites

    Archived

    This topic is now archived and is closed to further replies.

    ×
    ×
    • Create New...