Jump to content

Heater Cable and Sensor


Shah1905

Recommended Posts

Posted · Heater Cable and Sensor

Hey Guys,

I have the ultimaker 2 extended and just finished my second roll of PLA. Was having some trouble with the other plastics provided by the seller. Turns out, they were a different size. Luckily I have an Olsson block. While dismantling the wires from the old block I found the heater cable and the sensor to be stuck in the old block. I've tried everything (sewing machine oil etc.) to get it out but it wont budge. I got in touch with the seller and asked what can be done? could I get replacement cables? He mentioned that it would cost me 300$ !!!!! so far I've had absolute horrible luck with the machine only used 2 rolls of plastic and 2 months have gone by since it's been broken down. I'm super disappointed with both the machine and the service. Anyone else have any ideas??

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...