can i ask, did you have to clean this after it was printed or did the retraction work perfectly 100% for you ?
Thanks.
Ian
To be honest there was hardly any cleaning needed on this model. The only thing that went wrong was one support column inside the cathedral misprinted which was hardly noticable. Getting the model off of the printing bed took a little patience though (and a good sharp filling knife).
It looks quite stunning in the sun .. cannot wait to add some LED's
cheers,
Pete
-
Our picks
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 3 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
UltiMaker Cura 5.7 stable released
ArunC posted a topic in UltiMaker Cura,
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
-
-
- 26 replies
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
ian 32
thats brilliant !!!
congradulations on an absolutly wonderful print model !!!
fantastic.
Ian :-)
Link to post
Share on other sites