Jump to content
Ultimaker Community of 3D Printing Experts

Cura 13.06: support is smaller then the object


codeangel
 Share

Recommended Posts

Posted · Cura 13.06: support is smaller then the object

Hi Folks!

With Cura 13.06 / I have a problem that support structure is slightly smaller then the object it is supposed to support, please see here:

This is how Cura 13.03 did it, support structure is either alligned with object or even wider:

http://fallout.codeangels.com/misc/cura_support/cura_13.03.png

This is Cura 13.06, support structure is smaller then the model and leaves outer wall in the air, this causes bad prints:

http://fallout.codeangels.com/misc/cura_support/cura_13.06.png

How can I address this issue?

Thanks

Kirill

 

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...