UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
Nicolinux 288
I did not find a way to start it manually, so either I overlooked it or it is not available through the menu.
But why do you need it? I find that leveling in general is seldomly needed (except if you remove the glass plate after every print).
Link to post
Share on other sites
yvichrome 2
Yes ...
you're probably right and I only miss it much,beacuse it was there before .
I use it a lot when I train new users on the UM and let the perform a manual levelling, to check afterwards.
But in real life - you re right - its not so often needed - ?
Nevertheless, thanks for looking it up !
Link to post
Share on other sites