Is CURA compatible with Flashforge Guider IIs?

[graphicsgriffin 0]

Hi everyone.

 

I just got my Flashforge Guider IIs and I would like to use it with Cura. Is that possible?

 

Thanks

[brenyw 1]

Try this start-end gcode. I am having difficulty getting good sharp edges and good top surface finish when using other than Flashprint. (using PETG) Must be something to do with acceleration and jerk I am guessing.

1START_END .gcode

[r0ckl0bst3r 0]

Hi, I also have a Guider IIs and would like to use Cura. I'm new to 3D printing, so this might seem like an obvious question, but could you explain what I'd do with the gcode above? Cheers!