Jump to content

Random "unable to slice" message, but still slices


BlondieSL

Recommended Posts

Posted · Random "unable to slice" message, but still slices

I first has auto slicing enabled.

Randomly, after changing any number at all, it would say "unable to slice", but after a few seconds it would just go ahead and slice.

 

I then changed from auto slicing to manual.

 

Then I noticed that again, the random "unable to slice" message would happen as well.

 

Again, changing any number, even layer height.. .anything.  But not every single time.

 

Then I noticed if I made a change and clicked the Slice button, rather than the area changing to indicate it's going to slice, it just stayed the same.

So one would think the button didn't press and therefore, we'd press again.

 

This almost always caused the "unable to slice" message.

 

Again, it would pause for a few seconds then start to slice without an issue at that point.

 

 

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.9 beta released!
        In this release, we strike another blow against ugly Z seams, introduce Sketch series printers, add lots of Method series material profiles, and much more! Read on to discover everything that's been added in the Cura 5.9 beta release! 
        • 21 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Heart
          • Thanks
          • Like
        • 4 replies
    ×
    ×
    • Create New...