Jump to content

Ultimaker Original+ after z-limit swich clicks, bed goes down about 150mm when doing auto home


Recommended Posts

Posted · Ultimaker Original+ after z-limit swich clicks, bed goes down about 150mm when doing auto home

Just, assambled new Ultimaker Original+, but cannot set bed level to the right pisition. When doing auto home on ulticontroller or bed leveling via Cura, the bed goes to the nozzle, touches it, z limit switch clicks, and then bed is going down about 150mm and stays there. 

  • Link to post
    Share on other sites

    Posted · Ultimaker Original+ after z-limit swich clicks, bed goes down about 150mm when doing auto home

    Problem is solved, one wire connection to z-limit switch was loose.

    • Like 1
    Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.9 stable released!
        Here comes Cura 5.9 and in this stable release we have lots of material and printer profiles for UltiMaker printers, including the newly released Sketch Sprint. Additionally, scarf seams have been introduced alongside even more print settings and improvements.  Check out the rest of this article to find out the details on all of that and more
          • Like
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Heart
          • Thanks
          • Like
        • 7 replies
    ×
    ×
    • Create New...